Introducción

Use this guide to replace the pull-out antenna through the back of the device.

Partes

No se requieren partes.

  1. Remove the battery by sliding it down the rails to which it is connected.
    • Remove the battery by sliding it down the rails to which it is connected.

    Agregar Comentario

  2. Insert the Phillips 00 screwdriver into the holes that connect the key pad guard to the rear casing in the plastic rod.
    • Insert the Phillips 00 screwdriver into the holes that connect the key pad guard to the rear casing in the plastic rod.

    • The following step may require a substantial amount of force.

    • Use the screwdriver to push the rods towards each other until they click out of their locked positions.

    Agregar Comentario

    • Slide off the antenna guard and locate the four clips on the exterior of the rear casing.

    • Push the clips outward while simultaneously lifting the rear casing and keyguard away from the front casing.

    Agregar Comentario

    • Locate and unplug the black component of the current antenna from the motherboard.

    • Under the black component there should be a blue component.

    • Unscrew the blue component in order to free the antenna.

    Agregar Comentario

  3. Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    Reparte el espíritu de reparación esta Navidad
    Obtén $12 de descuento en tu compra de $50 o más con el código FIXMAS12
    • Slide the antenna out of the green tubing.

    • Slide the green tubing out of its hole.

    Agregar Comentario

    • Insert the new green tubing into the corresponding slot.

    Agregar Comentario

    • Insert the new antenna into the green tubing.

    Agregar Comentario

    • Screw the blue piece of the antenna into the threaded hole on the motherboard until it is tight.

    Agregar Comentario

    • Align the protruding wire on the black component with the corresponding hole on the motherboard.

    • Push the wire into the hole.

    Agregar Comentario

    • Reverse the instructions from Step 2 to re-install the keypad guard and rear casing onto the device.

    Agregar Comentario

    • Push down on the antenna guard until it clicks into place.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Andrew Lam

Miembro Desde 17/04/12

28 Reputación

4 Guías creadas

Equipo

Cal Poly, Team 9-46, Regan Spring 2012 Miembro de Cal Poly, Team 9-46, Regan Spring 2012

CPSU-REGAN-S12S9G46

5 Miembros

8 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 5

Últimos 30 Días: 12

Todo El Tiempo: 1,492