Repara tus cosas Comunidad Tienda

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

Motherboard

Introducción

This guide will help locate the motherboard for removal and/or repair.

Qué necesitas

  1. Motherboard, Battery: paso 1, imagen 1 de 1

    • Flip over the phone so that the back is facing up.

    • Pressing your thumb against the back cover, slide the cover off of the phone.

    Traducir

  2. Motherboard: paso 2, imagen 1 de 1

    • Remove the phone's battery.

    Traducir

  3. Motherboard, Motherboard: paso 3, imagen 1 de 2 Motherboard, Motherboard: paso 3, imagen 2 de 2

    • There are two tabs located at the top corners of the battery compartment. Use the iFixit opening tool to pry out those tabs.

    Traducir

  4. Motherboard: paso 4, imagen 1 de 1

    • Gently pull off the hinge cap from the top of the phone by hand.

    Traducir

  5. Motherboard: paso 5, imagen 1 de 1

    • Use a T6 Torx Screwdriver to remove the four 7.62mm screws located at the corners of the battery compartment.

    Traducir

  6. Motherboard: paso 6, imagen 1 de 2 Motherboard: paso 6, imagen 2 de 2

    • Open the phone and turn it on its side. You will see a seam around the Nokia’s side.

    • Use the iFixit opening tool to run along this seam to pop the clips holding the casing to the frame.

    Traducir

  7. Motherboard: paso 7, imagen 1 de 1

    • Use your hand to gently pull off the back panel from the bottom half of the phone.

    Traducir

  8. Motherboard: paso 8, imagen 1 de 1

    • Close the phone and place it on a flat surface.

    • Use the plastic opening tool or your finger to lift up the motherboard from the bottom casing.

    • Be careful when pulling up the board; there is still a ribbon cable attached to the back of the board.

    Traducir

  9. Motherboard: paso 9, imagen 1 de 1

    • Find the underside of the motherboard and locate the ribbon cable that attaches the board to the rest of the phone. Use the plastic opening tool to slowly detach the ribbon cable connector, then pull the motherboard away from the frame.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Autor

con 9 otros colaboradores

Andrew

Miembro Desde 10/04/10

397 Reputación

4 Guías creadas

Insignias: 8

+ 5 más insignias

Equipo

Cal Poly, Team 4-46, Amido Fall 2010 Miembro de Cal Poly, Team 4-46, Amido Fall 2010

CPSU-AMIDO-F10S4G46

4 Miembros

14 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 2

Todo El Tiempo: 454