Milwaukee 2704-20 Trigger Replacement

Introducción

Is your drill not functioning properly, specifically when it comes to pulling the trigger? If so, this guide will help you remove and replace your current faulty trigger mechanism. This guide strictly covers replacement of the trigger assembly only. For a full drill disassembly breakdown, refer to this guide.

Qué necesitas

Paso 1 Outer Case

Milwaukee 2704-20 Trigger Replacement, Outer Case: paso 1, imagen 1 de 2

Milwaukee 2704-20 Trigger Replacement, Outer Case: paso 1, imagen 2 de 2

Remove the battery from the drill.

Editar

Paso 2

Milwaukee 2704-20 Trigger Replacement: paso 2, imagen 3 de 3

Remove the indicated screws (M3 x 16mm Pan Hd. ST T-10 Screws) with screwdriver.

Editar

Paso 3

Milwaukee 2704-20 Trigger Replacement: paso 3, imagen 3 de 3

Gently lift the cover off the drill. Be careful not to force it or damage any of the internal components.
If the cover doesn't come off easily, check for any clips or latches that may be holding it in place. These can usually be released by pressing them with a small flathead screwdriver.

Editar

Paso 4 Trigger

Milwaukee 2704-20 Trigger Replacement, Trigger: paso 4, imagen 1 de 2

Milwaukee 2704-20 Trigger Replacement, Trigger: paso 4, imagen 2 de 2

Desolder the two solder joints on the trigger assembly.
USE CAUTION! Soldering irons get extremely hot, as will everything they make prolonged contact with.