Saltar al contenido principal

Introducción

The Surface Pro 4's heat sink cooling system consists of copper tubing and a connected copper plate. Here is how to remove it for replacement or to access the components below.

  1. Both sections of the heat sink are connected to the motherboard via a panel which is covered by a metal casing. Remove the casing by prying around the edges and then lifting the entire piece once it  is loose. Remove the casing by prying around the edges and then lifting the entire piece once it  is loose.
    • Both sections of the heat sink are connected to the motherboard via a panel which is covered by a metal casing.

    • Remove the casing by prying around the edges and then lifting the entire piece once it is loose.

  2. Remove the four 1.5mm Torx T5 screws  holding the main body of the heat sink to the motherboard Remove the four 1.5mm Torx T5 screws  holding the main body of the heat sink to the motherboard Remove the four 1.5mm Torx T5 screws  holding the main body of the heat sink to the motherboard
    • Remove the four 1.5mm Torx T5 screws holding the main body of the heat sink to the motherboard

  3. Remove the two 1.5mm Torx T3 screws holding the copper plate near the middle of the device. Remove the two 1.5mm Torx T3 screws holding the copper plate near the middle of the device.
    • Remove the two 1.5mm Torx T3 screws holding the copper plate near the middle of the device.

  4. Remove the 1.5mm Torx T4 screw holding the heat sink tubing to the frame of the device. Remove the 3.0mm Torx T4 screw.
    • Remove the 1.5mm Torx T4 screw holding the heat sink tubing to the frame of the device.

    • Remove the 3.0mm Torx T4 screw.

  5. You can now remove entire heat sink by lifting it out with your hands. Be sure to replace the thermal paste when installing the heat sink. Be sure to replace the thermal paste when installing the heat sink.
    • You can now remove entire heat sink by lifting it out with your hands.

    • Be sure to replace the thermal paste when installing the heat sink.

Conclusión

To reassemble your device, follow these instructions in reverse order.

10 personas más completaron esta guía.

Andrew Prater

Miembro Desde 01/02/16

4,802 Reputación

5 Guías creadas

Equipo

Metro State, Team 1-3, Carpenter Spring 2016 Miembro de Metro State, Team 1-3, Carpenter Spring 2016

MSU-CARPENTER-S16S1G3

2 Miembros

15 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 4

Ultimos 7 días: 37

Ultimos 30 días: 205

Todo El Tiempo: 11,385