Introducción

This guide is used for replacing the motherboard on the device . This makes the device to work at faster speeds.

  1. Use your thumb or fingernail on the edge/corner of the phone to pry the back cover off the phone.
    • Use your thumb or fingernail on the edge/corner of the phone to pry the back cover off the phone.

  2. Use the tweezers to pull back the sticker, revealing the screw underneath.
    • Use the tweezers to pull back the sticker, revealing the screw underneath.

    • Be careful when taking out the screws as they can strip easily

    • Use the T-4 bit to unscrew the screws in the 4 corners, along with the two acres in the middle left side

    • Using the T-4 bit, unscrew the two (2) screws

    • Keep these screws separate from the screws from back of the phone to ensure that the right screws go where they belong

    • Using the plastic opening tool to separate the screen from the back plastic casing

    • Use the tweezers to release the clip on the side of device, and remove the back of the phone.

    • Using the tweezers or a spudger, pull the gold tab up gently

    • Using the tweezers or spudger, pull the white circuit up gently to completely detach the screen from the phone

    • For Motherboard replacement skip to step 11 after finishing this step

    • Using the plastic opening tool, carefully get under the gold strip

    • Using tweezers pull up the camera. The camera just sits in there

    • using the tweezers pull up on the depth sensor. This is held in by a strong adhesive

    • Using the plastic opening tool, pry up the ear speaker. This is held in by strong adhesive.

    • Unscrew 2 remaining screws with T-4 bit.

    • Remove speaker using tweezers.

    • Use the plastic opening tool to lift up black tab

    • Using the tweezers, gently pull up on the gold tab

    • using the spudger, slowly get underneath the gold sticker to pry it up. Held down with strong adhesive

    • Remove orange insulator foam with tweezers.

    • Using the pry tool lift up on the black tab

    • Using the spudger, press out the motherboard.

    • Gently wiggle out the motherboard.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Ver Estadísticas:

Ultimas 24 Horas: 1

Últimos 7 Días: 2

Últimos 30 Días: 37

Todo El Tiempo: 64