Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use your thumb or fingernail on the edge/corner of the phone to pry the back cover off the phone.
-
-
Este paso está sin traducir. Ayuda a traducirlo
Herramienta utilizada en este paso:Tweezers$4.99-
Use the tweezers to pull back the sticker, revealing the screw underneath.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a T4 Torx driver to remove the screws in the four corners, along with the two in the middle left side (six total).
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a plastic opening tool to separate the screen from the back plastic casing
-
Use tweezers to release the clip on the side of device, and remove the back of the phone.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using the tweezers or a spudger, pull the gold tab up gently.
-
Using tweezers or a spudger, lift the white connector up gently to completely detach the screen from the phone.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a plastic opening tool to carefully get under the gold strip.
-
Use tweezers to pull up the camera.
-
Use tweezers to pull up on the depth sensor.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a plastic opening tool to pry up the ear speaker.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the plastic opening tool to lift up the black tab.
-
Use the tweezers to gently pull up on the gold tab.
-
Using the spudger, slowly get underneath the gold sticker and pry it up. This sticker is held down with a strong adhesive.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the tweezers to remove the orange insulator foam.
-