Repara tus cosas Comunidad Tienda

MerchSource the Black Series Boat Racer Gaskets Replacement

Introducción

This repair guide will show you how to replace the gaskets in the MerchSource the Black Series Boat Racers toy boat. The gaskets are foam pieces that secure the battery compartment in the boat from water leakage.

Qué necesitas

  1. MerchSource the Black Series Boat Racer Gaskets Replacement, Gaskets: paso 1, imagen 1 de 2 MerchSource the Black Series Boat Racer Gaskets Replacement, Gaskets: paso 1, imagen 2 de 2

    • Remove the screw on the top of the boat at the rear end using a Phillips #2 screwdriver.

    • Screw length is 16 mm.

    Editar

  2. MerchSource the Black Series Boat Racer Gaskets Replacement: paso 2, imagen 1 de 3 MerchSource the Black Series Boat Racer Gaskets Replacement: paso 2, imagen 2 de 3 MerchSource the Black Series Boat Racer Gaskets Replacement: paso 2, imagen 3 de 3

    • Remove the top of the boat by sliding it backwards and then pulling it off.

    Editar

  4. MerchSource the Black Series Boat Racer Gaskets Replacement: paso 3, imagen 1 de 2 MerchSource the Black Series Boat Racer Gaskets Replacement: paso 3, imagen 2 de 2

    • Grab the rubber gasket with tweezers and pull it out of the slot.

    Editar

  5. MerchSource the Black Series Boat Racer Gaskets Replacement: paso 4, imagen 1 de 3 MerchSource the Black Series Boat Racer Gaskets Replacement: paso 4, imagen 2 de 3 MerchSource the Black Series Boat Racer Gaskets Replacement: paso 4, imagen 3 de 3

    • Gently remove the gasket and replace with a new one.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 1

Todo El Tiempo: 258