Saltar al contenido principal

Introducción

Dim picture? No display? Discolored output? No problem! Use this guide to replace the burnt light bulb with a new one. To complete this replacement, you will need the following parts ready:

Herramientas

Partes

No se especificaron partes.

  1. Merch Source Projector Entertainment II Light Bulb Replacement, Outer Casing: paso 1, imagen 1 de 2 Merch Source Projector Entertainment II Light Bulb Replacement, Outer Casing: paso 1, imagen 2 de 2
    • Flip the projector onto its back and unscrew the nine 15mm screws using the Phillips #0 screw driver.

  2. Merch Source Projector Entertainment II Light Bulb Replacement: paso 2, imagen 1 de 1
    • Flip the projector right side up and unscrew the two 12mm screws on the light bulb panel located at the rear of the projector with a Phillips #0 screw head.

    • The bottom right panel screw does not come completely out the panel door.

  3. Merch Source Projector Entertainment II Light Bulb Replacement: paso 3, imagen 1 de 2 Merch Source Projector Entertainment II Light Bulb Replacement: paso 3, imagen 2 de 2
    • Using your hands, gently pry the top and bottom of the projector casing apart.

  4. Merch Source Projector Entertainment II Light Bulb Replacement, Remove light bulb assembly from housing unit: paso 4, imagen 1 de 3 Merch Source Projector Entertainment II Light Bulb Replacement, Remove light bulb assembly from housing unit: paso 4, imagen 2 de 3 Merch Source Projector Entertainment II Light Bulb Replacement, Remove light bulb assembly from housing unit: paso 4, imagen 3 de 3
    • Remove the light bulb from its housing unit.

    • Do not damage the 2 white cables leading into the light bulb panel.

  5. Merch Source Projector Entertainment II Light Bulb Replacement, Replace light bulb: paso 5, imagen 1 de 2 Merch Source Projector Entertainment II Light Bulb Replacement, Replace light bulb: paso 5, imagen 2 de 2
    • Remove the light bulb from the door panel by gently wiggling it back and forth. Do not twist the light bulb.

    • The light blub is held into the socket with prongs, and should easily pull straight out.

    What light bulb do I need?

    ingadewitt606 - Contestar

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Stephanie

Miembro Desde 08/01/15

276 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 18-3, Maness Winter 2015 Miembro de Cal Poly, Team 18-3, Maness Winter 2015

CPSU-MANESS-W15S18G3

3 Miembros

4 Guías creadas

Un Comentario

Mi nuevo proyector no prende la luz ni el ventilador al conectarlo al tomacorriente y encenderlo.

JAVIER MUNOZ - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 3

Ultimos 7 días: 7

Ultimos 30 días: 34

Todo El Tiempo: 1,292