Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
The access panel for all of these lights is on the inside of the trunk. There's one on each side. This guide will cover one side; simply repeat on the other to complete the job.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
The panel is secured with two thumb screws. Remove these.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull the panel out and away from the back of the car, being careful not to force the bulbs out of the holes.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
There are five bulbs in each tail light housing. They are as follows:
-
Brake light
-
Reverse light
-
Tail light
-
Turn signal
-
Side marker
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
To remove any of the bulbs simply turn them counter clockwise approximately a half turn and then pull them out of their socket.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Three of the bulbs are #1156
-
One is a #96
-
One is a small 4W blub
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Before installing the new bulb consider cleaning the socket with a soft metal wire brush such as the brass brush shown to help remove any corrosion.
-
Then install the new bulb, reassemble the device, and finally, be sure to test that all of your rear lights are working before going for a drive.
-
Cancelar: No complete esta guía.
10 personas más completaron esta guía.
2 comentarios
Very informative, descriptive and point on analysis.