Repara tus cosas Comunidad Tienda

Marshall MS-2 Speaker Replacement

Qué necesitas

  1. Marshall MS-2 Speaker Replacement, Disassembling Marshall MS-2 Micro Amp Case Disassembly: paso 1, imagen 1 de 1

    • First be sure to turn the power switch to the off position.

    • Do this by turning the leftmost knob counter-clockwise as until the line points to "off."

    Traducir

  2. Marshall MS-2 Speaker Replacement: paso 2, imagen 1 de 3 Marshall MS-2 Speaker Replacement: paso 2, imagen 2 de 3 Marshall MS-2 Speaker Replacement: paso 2, imagen 3 de 3

    • Now remove the battery.

    • On the back of the device locate the battery cover.

    • Remove it by pushing down on the clip.

    • Then pull the piece of fabric until the battery comes out.

    Traducir

  3. Marshall MS-2 Speaker Replacement: paso 3, imagen 1 de 2 Marshall MS-2 Speaker Replacement: paso 3, imagen 2 de 2

    • Use the long, skinny phillips head screwdriver to remove the 4 7/16" screws on the back of the device in the four corners.

    • Once unscrewed, do not try to take each screw out. Move to next step once all screwed have been unscrewed.

    Traducir

  5. Marshall MS-2 Speaker Replacement: paso 4, imagen 1 de 1

    • Now pull the back panel off and place it down as shown. Pull the panel straight up so you do not lose the screws.

    Traducir

  6. Marshall MS-2 Speaker Replacement, Speaker: paso 5, imagen 1 de 1
    Traducir

  7. Marshall MS-2 Speaker Replacement: paso 6, imagen 1 de 2 Marshall MS-2 Speaker Replacement: paso 6, imagen 2 de 2

    • Remove the two 7/16" screws located in the bottom left and top right corners with a phillips head screw driver. After removing the screws, the metal clips will need to be removed as well.

    Traducir

  8. Marshall MS-2 Speaker Replacement: paso 7, imagen 1 de 1

    • You may now remove the speaker by pulling it straight out.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Autor

con 6 otros colaboradores

MacKinley

Miembro Desde 10/22/13

811 Reputación

5 Guías creadas

Insignias: 10

+ 7 más insignias

Equipo

University of Maryland, Team 1-1, Shastany Fall 2013 Miembro de University of Maryland, Team 1-1, Shastany Fall 2013

UMD-SHASTANY-F13S1G1

Miembros de 3

5 Guías creadas

4 Guide Comments

So where do we find a replacement speaker? If no parts are required what is the point in taking the speaker out?

Patrick Gillett - Contestar

This speaker unavailable in Marlins. Any online sources. How should an untutored amateur repairer describe the replacement in order to get the right thing

Patrick Gillett - Contestar

Any speaker that will fit should work. Might want to check to make sure the Watts they consume are the same. I imagine that if you put a speaker in that consumes more Watts you could potentially over heat the power supply or other components.

MacKinley - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 29

Todo El Tiempo: 4,432