Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Hold the drill upright.
-
Place your finger on the white battery-release button.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Press and hold the white release button located on the front of the battery.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Slide the battery forward while pressing down on the white battery-release button.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Hold the drill upright with the back panel facing you.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unscrew two 18mm screws from the back panel with the Phillips PH2 screwdriver.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Apply slight pressure to the sides of the backplate and pull away from the drill.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Hold the drill so the back end is facing toward you.
-
Use the spudger to lift the spring clip out of the back notch.
-
Pull the spring clip forward and rest it in the front notch.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the tweezers to pull the drill brush away from the sleeve.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the plastic opening tool to release the clip connected to the drill brush.
-
Separate the drill brush away from the clip.
-
Cancelar: No complete esta guía.
3 personas más completaron esta guía.