Saltar al contenido principal

MacBook Unibody Model A1342 Rear Speaker Assembly Replacement

Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Qué necesitas

  1. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement, Rear Speaker Assembly: paso 1, imagen 1 de 1
    • Use the flat end of a spudger to pry the AirPort/Bluetooth cable connector up off the logic board.

  2. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: paso 2, imagen 1 de 1
    • Remove the following screws securing the right speaker assembly to the upper case:

    • One 12 mm Phillips screw.

    • One 3 mm Phillips screw.

  3. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: paso 3, imagen 1 de 1
    • Remove the single 2.2 mm Phillips screw inserted horizontally into the side of the optical drive.

  4. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: paso 4, imagen 1 de 2 MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: paso 4, imagen 2 de 2
    • Pry the AirPort and Bluetooth antenna connectors (3 total) up off the AirPort/Bluetooth card.

    • De-route the long antenna from its channel in the rear speaker housing.

  5. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: paso 5, imagen 1 de 1
    • Use the flat end of a spudger to pry the rear speaker cable connector up off the logic board.

  6. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: paso 6, imagen 1 de 1
    • Remove the rear speaker assembly from the upper case.

  7. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: paso 7, imagen 1 de 2 MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: paso 7, imagen 2 de 2
    • Carefully peel the AirPort/Bluetooth cable from its channel within the rear speaker assembly.

    • Use the flat end of a spudger to pry the AirPort/Bluetooth cable up off the rear speaker.

  8. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: paso 8, imagen 1 de 1
    • Remove three 3 mm Phillips screws securing the AirPort/Bluetooth board to the rear speaker assembly.

  9. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: paso 9, imagen 1 de 1
    • Lift the AirPort/Bluetooth board up off the rear speaker assembly.

Conclusión

To reassemble your device, follow these instructions in reverse order.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 695