Repara tus cosas Comunidad Tienda

MacBook Unibody Model A1342 LCD Replacement

Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Introducción

This guide is an internal prerequisite.

Qué necesitas

  1. MacBook Unibody Model A1342 LCD Replacement, LCD: paso 1, imagen 1 de 1

    • Remove following six screws securing the LCD to the rear display bezel:

    • Four 3.4 mm Phillips.

    • Two 3 mm Phillips.

    Traducir

  2. MacBook Unibody Model A1342 LCD Replacement: paso 2, imagen 1 de 1

    • Do not try to remove the LCD yet. The circuitry along its lower edge is wedged in a gap along the lower edge of the display recess in the plastic display assembly.

    • Hold the display vertically and tip it enough to grab the top edge of the LCD and rotate it slightly out of the display assembly, being careful not to break the circuitry off its lower edge.

    Traducir

  4. MacBook Unibody Model A1342 LCD Replacement: paso 3, imagen 1 de 1

    • Peel the piece of tape covering the display data cable connector away from the edge closest to the LCD.

    Traducir

  5. MacBook Unibody Model A1342 LCD Replacement: paso 4, imagen 1 de 2 MacBook Unibody Model A1342 LCD Replacement: paso 4, imagen 2 de 2

    • Use the tip of a spudger to flip up the thin steel retaining clip securing the display data cable to its socket on the LCD.

    • Pull the display data cable straight away from its socket on the LCD.

    • Lift the LCD out of the display assembly and set it aside.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 791