Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
-
Con la carcasa cerrada, coloca el Unibody con la parte superior hacia abajo sobre una superficie plana.
-
Presiona el lado ranurado de la pestaña de apertura de la puerta de acceso, lo suficiente como para poder agarrar el extremo libre. Levanta la pestaña de apertura hasta que quede vertical.
-
-
-
Retira los siguientes ocho tornillos que aseguran la carcasa inferior al chasis:
-
Un tornillo Phillips de 3 mm.
-
Tres tornillos Phillips de 13.5 mm.
-
Cuatro tornillos Phillips de 3.5 mm.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the four 10.3 mm Phillips screws securing the mid wall to the upper case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the following screws securing the battery connector cover to the upper case:
-
One 2.5 mm Phillips screw.
-
Two 1.5 mm Phillips screws.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the battery connector cover out of the upper case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the single 2.7 mm Phillips screw securing the battery cable cover to the upper case.
-
Lift the battery cable cover out of the upper case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Using a spudger, pry the battery level indicator cable connector straight up off the logic board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Peel the battery connector cable off the adhesive securing it to the upper case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull the battery connector cable slightly toward the logic board to give yourself enough slack to grab the cable with your fingers.
-
Disconnect the cable by pulling it straight away from the logic board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
De-route the battery connector cable through the gap in the upper case and remove it from the computer.
-
Cancelar: No complete esta guía.
13 personas más completaron esta guía.
Un comentario
When reinstalling the battery connector/cable, placement of the connector is critical. If the connector isn't positioned accurately, contact with the battery terminals won't be completed. The battery connector cover will help you align the connector, but there will still be a little leeway as you screw the cover down. Position the battery first, to adjust the connector's position; then remove the battery and tighten the cover screws down. You may even want to try plugging the computer into the AC charger before completing the cover attachment, to ensure that battery is charging and the connector is correctly positioned.