Saltar al contenido principal

MacBook Pro 17" Unibody Lower Case Replacement

Qué necesitas

  1. MacBook Pro 17" Unibody Lower Case Replacement, Lower Case: paso 1, imagen 1 de 1
    • Remove the following ten screws securing the lower case to the upper case:

    • Three 13.5 mm Phillips screws.

    • Seven 3 mm Phillips screws.

  2. MacBook Pro 17" Unibody Lower Case Replacement: paso 2, imagen 1 de 2 MacBook Pro 17" Unibody Lower Case Replacement: paso 2, imagen 2 de 2
    • Wedge your fingers between the lower case and the vent, and lift upward to release the two clips holding the lower case to the upper case.

    • During reassembly, carefully align the lower case and then press it firmly until both clips engage.

    • Remove the lower case.

Conclusión

To reassemble your device, follow these instructions in reverse order.

19 personas más completaron esta guía.

Un comentario

Is there a DIY on replacing the rubber feet?

retrotechpost - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 2

Ultimos 7 días: 11

Ultimos 30 días: 35

Todo El Tiempo: 17,834