Saltar al contenido principal

MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement

Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Qué necesitas

  1. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement, Optical Drive: paso 1, imagen 1 de 1
    • Use the flat end of a spudger to pry the AirPort/Bluetooth ribbon cable connector up off the logic board.

  2. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: paso 2, imagen 1 de 1
    • Disconnect the camera cable by pulling its connector away from the socket (toward the optical drive) on the logic board.

  3. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: paso 3, imagen 1 de 1
    • Use the flat end of a spudger to pry the optical drive connector up off the logic board.

  4. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: paso 4, imagen 1 de 2 MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: paso 4, imagen 2 de 2
    • Remove the two Phillips screws securing the AirPort/Bluetooth board housing.

    • Carefully rotate the AirPort/Bluetooth board housing (with AirPort/Antenna cables still attached) out of the lower case.

  5. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: paso 5, imagen 1 de 1
    • Remove the following three Phillips screws securing the optical drive to the upper case:

    • One 4.5 mm Phillips screw securing the optical drive bracket to the upper case near the fan.

    • Two 2.5 mm Phillips screws securing the optical drive to the upper case near the optical drive opening.

  6. MacBook Pro 15" Unibody Mid 2010 Optical Drive Replacement: paso 6, imagen 1 de 1
    • Lift the optical drive near its connector and pull it away from the upper case to remove it from the computer.

Conclusión

To reassemble your device, follow these instructions in reverse order.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 956