Repara tus cosas Comunidad Tienda

MacBook Pro 15" Unibody Mid 2010 Lower Case Replacement

Introducción

Remove the lower case to access most of your MacBook Pro's internals.

Qué necesitas

  1. MacBook Pro 15" Unibody Mid 2010 Lower Case Replacement, Lower Case: paso 1, imagen 1 de 1

    • Remove the following ten screws securing the lower case to the upper case:

    • Three 13.5 mm (14.1 mm) Phillips screws.

    • Seven 3 mm Phillips screws.

    • When removing these screws, note how they come out at a slight angle. They must be reinstalled the same way.

    Traducir

  3. MacBook Pro 15" Unibody Mid 2010 Lower Case Replacement: paso 2, imagen 1 de 1

    • Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.

    • Remove the lower case and set it aside.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

46 personas más completaron esta guía.

Un comentario

When replacing the lower case, be sure to re-seat the clips that popped when removing it. There are two, located near the edge of the battery and the motherboard. Apply firm pressure over these spots until the clips click again, before replacing the screws.

keithbartholomew - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 15

Ultimos 30 días: 29

Todo El Tiempo: 41,001