Repara tus cosas

Derecho a reparar

Tienda

MacBook Pro 15" Unibody Mid 2009 Left Fan Replacement

Escrito Por: Walter Galan (y 6 de otros participantes)
  • Comentarios: 4
  • Favoritos: 15
  • Terminaciones: 70

Dificultad

Moderado

Pasos

4

Tiempo Requerido

5 - 40 minutos

Secciones

2

Banderas

0

Introducción

Replace a faulty fan to keep temperatures down.

  1. Remove the following ten screws securing the lower case to the upper case:

    • Remove the following ten screws securing the lower case to the upper case:

    • Seven 3 mm Phillips screws.

    • Three 13.5 mm Phillips screws.

    Editar

    May be helpful to have more distinct colors to identify the different screws.

    Victor Caamano - Contestar

  2. Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case. Remove the lower case and set it aside.

    • Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.

    • Remove the lower case and set it aside.

    Editar

  3. El kit de herramientas esencial

    Las herramientas más útiles en nuestro kit más compacto.

    Compra ahora

    El kit de herramientas esencial

    Las herramientas más útiles en nuestro kit más compacto.

    Compra ahora

  4. Use the flat end of a spudger to disconnect the left fan connector from the logic board. It is useful to twist the spudger axially from beneath the fan cable wires to release the connector. The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same.

    • Use the flat end of a spudger to disconnect the left fan connector from the logic board.

    • It is useful to twist the spudger axially from beneath the fan cable wires to release the connector.

    • The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same.

    Editar

  5. Remove three T6 Torx screws securing the left fan to the logic board. Lift the left fan out of the upper case.

    • Remove three T6 Torx screws securing the left fan to the logic board.

    • Lift the left fan out of the upper case.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

70 personas más completaron esta guía.

3 comentarios

Agregar un comentario

Connecting the fan to the logic board is unclear. Could you walk through that a little more clearly?

kamoako1 - Contestar

When connecting the new fan to the logic board, set the connector piece above its socket on the logic board and then gently press down. It should click together.

k. -

quite easy. i’m very happy with this manual. Though connecting the new fan until it clicks is the most difficult part. thank you!

Oliver - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 3

Ultimos 7 días: 15

Ultimos 30 días: 72

Todo El Tiempo: 40,829