Introducción

Replace a faulty fan to keep temperatures down.

Remove the following ten screws securing the lower case to the upper case:
  • Remove the following ten screws securing the lower case to the upper case:

    • Seven 3 mm Phillips screws.

    • Three 13.5 mm Phillips screws.

Agregar Comentario

Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.
  • Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.

  • Remove the lower case and set it aside.

Agregar Comentario

  • Use the flat end of a spudger to disconnect the left fan connector from the logic board.

  • It is useful to twist the spudger axially from beneath the fan cable wires to release the connector.

  • The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same.

Agregar Comentario

  • Remove three T6 Torx screws securing the left fan to the logic board.

  • Lift the left fan out of the upper case.

Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

65 personas más completaron esta guía.

Connecting the fan to the logic board is unclear. Could you walk through that a little more clearly?

kamoako1 - Contestar

When connecting the new fan to the logic board, set the connector piece above its socket on the logic board and then gently press down. It should click together.

k. -

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 2

Últimos 7 Días: 30

Últimos 30 Días: 95

Todo El Tiempo: 38,406