Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
-
Con el estuche cerrado, coloca el Unibody boca arriba sobre una superficie plana.
-
Presiona el lado ranurado del pestillo de liberación de la puerta de acceso lo suficiente para agarrar el extremo libre. Levanta el pestillo de liberación hasta que quede vertical.
-
-
-
Agarra la lengüeta de plástico translúcido y extrae la batería de la Unibody.
-
Si se presiona el pestillo, se bloqueará la batería en su lugar.
-
-
-
Retira los siguientes ocho tornillos que sujetan la carcasa inferior al chasis:
-
Un tornillo Phillips de 5.4 mm.
-
Tres tornillos Phillips de 14 mm.
-
Cuatro tornillos Phillips de 3.5 mm.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the camera cable by pulling the male end straight away from its socket.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Deroute the camera data cable from the channel in the optical drive.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use a spudger to pry the optical drive connector straight up off the logic board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove two 8 mm Phillips screws securing the camera cable bracket to the upper case.
-
Lift the camera cable bracket out from the upper case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the following three Phillips screws securing the optical drive to the upper case:
-
One 3.5 mm Phillips screw.
-
Two 2.5 mm Phillips screws.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the optical drive from its left edge and pull it out of the computer.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the optical drive cable by pulling it straight away from the optical drive.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the two black Phillips #0 screws securing the small metal mounting bracket. Transfer this bracket to your new optical drive or hard drive enclosure.
-
Cancelar: No complete esta guía.
73 personas más completaron esta guía.
4 comentarios
Be extremely careful removing the drive retainer bracket screws. Stop immediately if they resist. These were extremely tight in my case, and I (carelessly) ended up stripping two, even using the correct screwdriver. Keep your extractor handy. (Apple technicians suggest the Alden Grabit-Micro.)
This was super easy. I just took mine apart and found a piece of tape lodged in it. Works great now. Thanks.