Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
-
Utiliza los dedos para empujar las dos lengüetas de liberación de la batería y sácala del ordenador.
-
-
-
Retira los dos tornillos Phillips de 2,8 mm en el compartimento de la batería cerca del pestillo.
-
-
-
-
Levanta la parte trasera de la caja y desliza los dedos por los laterales, liberando la caja a medida que avanzas. Una vez que hayas liberado los laterales, es posible que tengas que mover la caja hacia arriba y hacia abajo para liberar la parte delantera de la caja superior (hay algunos clips de plástico ocultos que hay que quitar).
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the right fan cable from the logic board by placing a spudger beneath the cable and lifting up.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the three silver T6 Torx screws securing the right fan to the logic board and lower case.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift the right fan up and carefully peel up the tape securing the fan to the heat sink as you go.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Disconnect the right thermal sensor cable from the logic board by placing a spudger beneath the cable and lifting up.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Peel up the orange Kapton tape covering the right thermal sensor.
-
Use a spudger to pry the right thermal sensor off the lower case.
-
Cancelar: No complete esta guía.
Una persona más ha completado esta guía.