Saltar al contenido principal

MacBook Pro 13" Unibody Early 2011 Hard Drive Replacement

Sólo Prerrequisito
Esta guía solo debería usarse como prerrequisito para otras guías. Por tanto, estará incompleta.

Qué necesitas

  1. MacBook Pro 13" Unibody Early 2011 Hard Drive Replacement, Hard Drive: paso 1, imagen 1 de 1
    • Remove the two Phillips screws securing the hard drive bracket to the upper case.

    • These screws will remain attached to the hard drive bracket.

  2. MacBook Pro 13" Unibody Early 2011 Hard Drive Replacement: paso 2, imagen 1 de 1
    • Remove the hard drive bracket.

    • The hard drive bracket may be firmly seated against the upper case.

  3. MacBook Pro 13" Unibody Early 2011 Hard Drive Replacement: paso 3, imagen 1 de 1
    • Use the attached pull tab to lift the hard drive out of the upper case.

    • Don't try to completely remove the hard drive just yet. It is still attached to the hard drive cable.

  4. MacBook Pro 13" Unibody Early 2011 Hard Drive Replacement: paso 4, imagen 1 de 2 MacBook Pro 13" Unibody Early 2011 Hard Drive Replacement: paso 4, imagen 2 de 2
    • Pull the hard drive cable away from the body of the hard drive.

    • Remove the hard drive.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 1,323