Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Tienda

Introducción

Prereq to disconnect the battery

Partes

No se especificaron partes.

  1. If necessary, remove the plastic cover adhered to the battery contact board.
    • If necessary, remove the plastic cover adhered to the battery contact board.

  2. Use the flat end of a spudger to lift the battery connector straight up out of its socket on the logic board. Be sure you lift up only on the connector itself, not the socket, or you risk permanent damage to the logic board.
    • Use the flat end of a spudger to lift the battery connector straight up out of its socket on the logic board.

    • Be sure you lift up only on the connector itself, not the socket, or you risk permanent damage to the logic board.

  3. Bend the battery connector up out of the way to prevent accidental contact with its socket during your repair.
    • Bend the battery connector up out of the way to prevent accidental contact with its socket during your repair.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Sam Goldheart

Miembro Desde 18/10/12

436,490 Reputación

547 Guías creadas

Equipo

iFixit Miembro de iFixit

Community

134 Miembros

15,620 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 714