Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Herramienta utilizada en este paso:Magnetic Project Mat$19.95
-
Quitar los siguientes diez tornillos que unen la tapa inferior con el cuerpo:
-
Dos tornillos Pentalobe P5 de 2.3mm
-
Ocho tornillos Pentalobe P5 de 3.0mm
-
-
-
Remueve la cubierta de plástico adherida a la placa de contacto de la batería.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the single 2.7 mm T5 Torx screw securing the AirPort board to the I/O board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the flat end of a spudger to pry and disconnect the three antenna cable connectors from the AirPort board.
-
Connect the long-sleeved cable to the center socket.
-
The short-sleeved cable connects next to the screw.
-
The remaining cable has no sleeve, and connects in the last empty socket, next to the fan.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Move the antenna cables aside, clear of the AirPort board.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Wedge a plastic opening tool between the AirPort board (side nearest the I/O ports) and the I/O board.
-
Gently pry the AirPort board upwards, but do not remove it.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Pull the AirPort board straight out of its socket on the I/O board.
-
Cancelar: No complete esta guía.
17 personas más completaron esta guía.