Repara tus cosas Comunidad Tienda

MacBook Air 13" Early 2017 AirPort/Bluetooth Card Replacement

Introducción

Use this guide to restore wireless connectivity to your MacBook Air 13" Early 2017 by replacing the Airport/Bluetooth card.

Qué necesitas

  1. MacBook Air 13" Early 2017 AirPort/Bluetooth Card Replacement, Lower Case: paso 1, imagen 1 de 1
    Herramienta utilizada en este paso:
    P5 Pentalobe Screwdriver Retina MacBook Pro and Air
    $5.99
    Comprar

    • Before proceeding, power down your MacBook. Close the display and lay it on a soft surface, top-side down.

    • Use a P5 Pentalobe driver to remove ten screws securing the lower case, of the following lengths:

    • Two 9 mm screws

    • Eight 2.6 mm screws

    Traducir

  2. MacBook Air 13" Early 2017 AirPort/Bluetooth Card Replacement: paso 2, imagen 1 de 1

    • Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.

    • Remove the lower case and set it aside.

    Traducir

  4. MacBook Air 13" Early 2017 AirPort/Bluetooth Card Replacement, Battery Connector: paso 3, imagen 1 de 2 MacBook Air 13" Early 2017 AirPort/Bluetooth Card Replacement, Battery Connector: paso 3, imagen 2 de 2

    • To ensure that everything is de-energized and won't turn on while you're working, it is recommended that you disconnect the battery.

    • Grab the clear plastic pull tab attached to the battery connector and pull it parallel to the board toward the front edge of the Air.

    • Do not lift upward on the connector as you disconnect it or you risk damage to the connector socket.

    Traducir

  5. MacBook Air 13" Early 2017 AirPort/Bluetooth Card Replacement, AirPort/Bluetooth Card: paso 4, imagen 1 de 2 MacBook Air 13" Early 2017 AirPort/Bluetooth Card Replacement, AirPort/Bluetooth Card: paso 4, imagen 2 de 2

    • Use the flat end of a spudger to pry both antenna connectors up from their sockets on the AirPort/Bluetooth card.

    Traducir

  6. MacBook Air 13" Early 2017 AirPort/Bluetooth Card Replacement: paso 5, imagen 1 de 1

    • Remove the single 2.9 mm T5 Torx screw securing the AirPort/Bluetooth card to the logic board.

    Traducir

  7. MacBook Air 13" Early 2017 AirPort/Bluetooth Card Replacement: paso 6, imagen 1 de 2 MacBook Air 13" Early 2017 AirPort/Bluetooth Card Replacement: paso 6, imagen 2 de 2

    • Slightly lift the free end of the AirPort/Bluetooth card and pull it out of its socket on the logic board.

    • To avoid damaging its socket on the logic board, do not excessively lift the free end of the AirPort/Bluetooth card.

    • Remove the AirPort/Bluetooth card from the Air.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

9 personas más completaron esta guía.

Autor

con 1 otro colaborador

Adam O'Camb

Miembro Desde 04/11/15

196,194 Reputación

416 Guías creadas

Insignias: 39

+ 36 más insignias

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 5

Ultimos 7 días: 49

Ultimos 30 días: 210

Todo El Tiempo: 9,251