Saltar al contenido principal

Introducción

Prereq to disconnect the battery.

Partes

No se especificaron partes.

  1. In this step you will disconnect the battery to help avoid shorting out any components during service. Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.
    • In this step you will disconnect the battery to help avoid shorting out any components during service.

    • Use the flat end of a spudger to pry both short sides of the battery connector upward to disconnect it from its socket on the logic board.

    • Bend the battery cable slightly away from the logic board so the connector will not accidentally bend back and make contact with its socket.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Sam Goldheart

Miembro Desde 18/10/12

390,684 Reputación

545 Guías creadas

Equipo

iFixit Miembro de iFixit

Community

107 Miembros

9,591 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 34