Introducción
Prerequisito solamente
Qué necesitas
-
-
Retire los cuatro (dos en cada lado) tornillos T8 de 6,5 mm que sujetan el disco duro a la bandeja de la unidad.
-
-
Para volver a armar su dispositivo, siga estas instrucciones en orden inverso.
Para volver a armar su dispositivo, siga estas instrucciones en orden inverso.
Cancelar: No complete esta guía.
4 personas más completaron esta guía.
Un agradecimiento especial a estos traductores:
100%
Estos traductores nos están ayudando a reparar el mundo! ¿Quieres contribuir?
Empezar a traducir ›
Like others, a T8 screw driver worked best for me on the 4 hard drive screws.
sorinjc - Contestar
it is t8 not t9. you owe me a TR6 Torx Security bit :D
giammin - Contestar
I found the 4 screws quite hard to remove and needed to use an 8mm spanner on the back of my T8 screwdriver to get them loose.
Reiner Friedel - Contestar
Screws have loctite residue. I put a tiny drop of fresh blue (semi-permanent) on each screw before reinstalling.
Jon Scott - Contestar
T9 was the right one for mine
Bill Pennock - Contestar
T9 Torx from recommended barely allowed me to remove these screws. I had to press very strong them into screws, so that pressure and minimal adhesion made it possible to move something.
Vitalijs Ozornins - Contestar
T8 was more appropriate for me !!!
afajner - Contestar
The instructions at the top recommend a T9 but the link plops a TR9 into your basket. In any event, the T8 works better.
tom - Contestar
T8 was also good for me. Mini was manufactured in 2016 October.
soul.tan - Contestar
TR7 did the job.
Benni Piron - Contestar
Is this a security screwdriver just like the TR6 Security Screwdriver?
Shubham Ojha - Contestar
When i did the re-assembly as I was adding a drive to a pcie only mac, i didnt have any t8 screws (so used standard phllips onces which came with the sata kit but i struggled to make sure the wires were out of the way. I dont know if the configuration for mac minis with drive is slightly different but you need to be careful not to screw down any of the wires (i think for IR sensors).
Edward Chandler - Contestar
Can anyone confirm a T8S (security) driver is needed for this, not a non-security T8?
Cornfritter - Contestar