Saltar al contenido principal
  1. Este paso está sin traducir. Ayuda a traducirlo

    Remove any broken or damaged feet. Remove any pieces from the old foot that may have broken off in the foot hole. Use tweezers to peel up and remove the old adhesive tape from the foot pad.
    • Remove any broken or damaged feet.

    • Remove any pieces from the old foot that may have broken off in the foot hole.

    • Use tweezers to peel up and remove the old adhesive tape from the foot pad.

  2. Este paso está sin traducir. Ayuda a traducirlo

    Scrub the foot pad with adhesive remover to remove any remaining adhesive.
    • Scrub the foot pad with adhesive remover to remove any remaining adhesive.

  3. Este paso está sin traducir. Ayuda a traducirlo

    Wipe the foot pad with an alcohol prep pad to remove any residue left by the cleaner.
    • Wipe the foot pad with an alcohol prep pad to remove any residue left by the cleaner.

  4. Este paso está sin traducir. Ayuda a traducirlo

    Peel a replacement foot from the plastic backing.
    • Peel a replacement foot from the plastic backing.

  5. Este paso está sin traducir. Ayuda a traducirlo

    Align the new foot inside the foot pad. Make sure the alignment nub on the foot is lined up with the small hole near the perimeter of the pad. Lay the foot down while keeping it properly aligned.
    • Align the new foot inside the foot pad.

    • Make sure the alignment nub on the foot is lined up with the small hole near the perimeter of the pad.

    • Lay the foot down while keeping it properly aligned.

    • Check for proper alignment from the inside of the lower case. Use tweezers to slide the alignment nub so it lines up with the hole.

  6. Este paso está sin traducir. Ayuda a traducirlo

    Press the new foot down firmly with your finger and maintain pressure for 30 seconds to set the pressure sensitive adhesive. Support the other side of the cover while you press the foot down.
    • Press the new foot down firmly with your finger and maintain pressure for 30 seconds to set the pressure sensitive adhesive. Support the other side of the cover while you press the foot down.

    • Repeat the last six steps for any broken or damaged feet.

Linea de Meta

Una persona más ha completado esta guía.

Arthur Shi

Miembro Desde 03/01/18

172,997 Reputación

428 Guías creadas

Equipo

iFixit Miembro de iFixit

Community

138 Miembros

16,983 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 0

Todo El Tiempo: 280