Repara tus cosas Comunidad Tienda

Esta guía ha sufrido modificaciones. Revisa la última versión sin revisar.

MSI GP60 2PE Leopard Wireless Card Replacement

Introducción

Is your wireless card not working? Here's a guide to replace it. Make sure you follow each step accordingly and carefully replace the wireless card.

Qué necesitas

  1. MSI GP60 2PE Leopard Wireless Card Replacement, Battery: paso 1, imagen 1 de 1

    • Flip MSI GP60 2PE Leopard, so that the back is facing up.

    Traducir

  2. MSI GP60 2PE Leopard Wireless Card Replacement: paso 2, imagen 1 de 1

    • Find the unlock tab located on the upper right side of the device, then slide it to the right.

    Traducir

  3. MSI GP60 2PE Leopard Wireless Card Replacement: paso 3, imagen 1 de 3 MSI GP60 2PE Leopard Wireless Card Replacement: paso 3, imagen 2 de 3 MSI GP60 2PE Leopard Wireless Card Replacement: paso 3, imagen 3 de 3

    • Slide and hold the release tab on the left side of the battery, so that you can remove the battery.

    Traducir

  4. MSI GP60 2PE Leopard Wireless Card Replacement: paso 4, imagen 1 de 3 MSI GP60 2PE Leopard Wireless Card Replacement: paso 4, imagen 2 de 3 MSI GP60 2PE Leopard Wireless Card Replacement: paso 4, imagen 3 de 3

    • While holding the release tab, remove the battery slowly.

    Traducir

  6. MSI GP60 2PE Leopard Wireless Card Replacement, Back Panel: paso 5, imagen 1 de 1

    • Flip the device over so the back is facing up.

    Traducir

  7. MSI GP60 2PE Leopard Wireless Card Replacement: paso 6, imagen 1 de 2 MSI GP60 2PE Leopard Wireless Card Replacement: paso 6, imagen 2 de 2

    • Remove the four 5mm screws from the back of the device using a Phillips #00 screwdriver.

    • There is a screw located under the battery; lift the battery up to access it.

    Traducir

  8. MSI GP60 2PE Leopard Wireless Card Replacement: paso 7, imagen 1 de 2 MSI GP60 2PE Leopard Wireless Card Replacement: paso 7, imagen 2 de 2

    • Once all four screws are removed, lift the back off.

    Traducir

  9. MSI GP60 2PE Leopard Wireless Card Replacement, Wireless Card: paso 8, imagen 1 de 1

    • Locate the wireless card.

    Traducir

  10. MSI GP60 2PE Leopard Wireless Card Replacement: paso 9, imagen 1 de 1

    • Using a Phillips #00 screwdriver, remove the one 2 mm screw that is holding the wireless card in place.

    Traducir

  11. MSI GP60 2PE Leopard Wireless Card Replacement: paso 10, imagen 1 de 1

    • Carefully remove the wireless card.

    • Pay close attention to the two wires attached to wireless card.

    Traducir

  12. MSI GP60 2PE Leopard Wireless Card Replacement: paso 11, imagen 1 de 2 MSI GP60 2PE Leopard Wireless Card Replacement: paso 11, imagen 2 de 2

    • Remove the wires connecting to the wireless card by pinching around the base where they connect, then carefully disconnect them.

    • The wires should come off fairly easily.

    • Avoid yanking or pulling too hard. This can result in the wires breaking.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 9

Ultimos 30 días: 25

Todo El Tiempo: 1,330