Repara tus cosas Comunidad Tienda

MSI GP60 2PE Leopard Wireless Card Replacement

Introducción

Is your wireless card not working? Here's a guide to replace it. Make sure you follow each step accordingly and carefully replace the wireless card.

Qué necesitas

  1. MSI GP60 2PE Leopard Wireless Card Replacement, Battery: paso 1, imagen 1 de 1

    • Flip MSI GP60 2PE Leopard, so that the back is facing up.

    Editar

  2. MSI GP60 2PE Leopard Wireless Card Replacement: paso 2, imagen 1 de 1

    • Find the unlock tab located on the upper right side of the device, then slide it to the right.

    Editar

  3. MSI GP60 2PE Leopard Wireless Card Replacement: paso 3, imagen 1 de 3 MSI GP60 2PE Leopard Wireless Card Replacement: paso 3, imagen 2 de 3 MSI GP60 2PE Leopard Wireless Card Replacement: paso 3, imagen 3 de 3

    • Slide and hold the release tab on the left side of the battery, so that you can remove the battery.

    Editar

  4. MSI GP60 2PE Leopard Wireless Card Replacement: paso 4, imagen 1 de 3 MSI GP60 2PE Leopard Wireless Card Replacement: paso 4, imagen 2 de 3 MSI GP60 2PE Leopard Wireless Card Replacement: paso 4, imagen 3 de 3

    • While holding the release tab, remove the battery slowly.

    Editar

  6. MSI GP60 2PE Leopard Wireless Card Replacement, Back Panel: paso 5, imagen 1 de 1

    • Flip the device over so the back is facing up.

    Editar

  7. MSI GP60 2PE Leopard Wireless Card Replacement: paso 6, imagen 1 de 2 MSI GP60 2PE Leopard Wireless Card Replacement: paso 6, imagen 2 de 2

    • Remove the four 5mm screws from the back of the device using a Phillips #00 screwdriver.

    • There is a screw located under the battery; lift the battery up to access it.

    Editar

  8. MSI GP60 2PE Leopard Wireless Card Replacement: paso 7, imagen 1 de 2 MSI GP60 2PE Leopard Wireless Card Replacement: paso 7, imagen 2 de 2

    • Once all four screws are removed, lift the back off.

    Editar

  9. MSI GP60 2PE Leopard Wireless Card Replacement, Wireless Card: paso 8, imagen 1 de 1

    • Locate the wireless card.

    Editar

  10. MSI GP60 2PE Leopard Wireless Card Replacement: paso 9, imagen 1 de 1

    • Using a Phillips #00 screwdriver, remove the one 2 mm screw that is holding the wireless card in place.

    Editar

  11. MSI GP60 2PE Leopard Wireless Card Replacement: paso 10, imagen 1 de 1

    • Carefully remove the wireless card.

    • Pay close attention to the two wires attached to wireless card.

    Editar

  12. MSI GP60 2PE Leopard Wireless Card Replacement: paso 11, imagen 1 de 2 MSI GP60 2PE Leopard Wireless Card Replacement: paso 11, imagen 2 de 2

    • Remove the wires connecting to the wireless card by pinching around the base where they connect, then carefully disconnect them.

    • The wires should come off fairly easily.

    • Avoid yanking or pulling too hard. This can result in the wires breaking.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 1

Ultimos 7 días: 4

Ultimos 30 días: 13

Todo El Tiempo: 1,313