Saltar al contenido principal

Introducción

Looking to replace your fan? This guide will help you do so with only a couple steps.

Partes

No se especificaron partes.

  1. Flip the device over so the back is facing up.
    • Flip the device over so the back is facing up.

  2. Remove the four 5mm screws from the back of the device using a Phillips #00 screwdriver. There is a screw located under the battery; lift the battery up to access it.
    • Remove the four 5mm screws from the back of the device using a Phillips #00 screwdriver.

    • There is a screw located under the battery; lift the battery up to access it.

  3. Kits de Reparación de Batería de iPhone

    Sólo $29.99

    Buy Now

    Kits de Reparación de Batería de iPhone

    Sólo $29.99

    Buy Now
  4. Once all four screws are removed, lift the back off. Once all four screws are removed, lift the back off.
    • Once all four screws are removed, lift the back off.

  5. Remove the  three 5 mm screws from the fan with a Phillips #00 screwdriver. Remove the  three 5 mm screws from the fan with a Phillips #00 screwdriver.
    • Remove the three 5 mm screws from the fan with a Phillips #00 screwdriver.

  6. Pull the wire on the bottom left of the fan out of the socket. Pull the wire gently; pulling too hard could damage the wire. Pull the wire gently; pulling too hard could damage the wire.
    • Pull the wire on the bottom left of the fan out of the socket.

    • Pull the wire gently; pulling too hard could damage the wire.

  7. Remove the fan. Remove the fan.
    • Remove the fan.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 2

Últimos 30 Días: 26

Todo El Tiempo: 248