Repara tus cosas Comunidad Tienda

Logitech M100 USB Cable Replacement

Introducción

This guide will detail how to disassemble a Logitech M100 mouse and replace its USB cable. This process is relatively universal, so it can be applied to a number of similar mice.

Qué necesitas

  1. Logitech M100 USB Cable Replacement, USB Cable: paso 1, imagen 1 de 2 Logitech M100 USB Cable Replacement, USB Cable: paso 1, imagen 2 de 2

    • Not all variants of this mouse require the mouse feet to be taken off for disassembly, but their removal is detailed anyway.

    • Carefully remove the feet of the mouse with an opening pick.

    • Keep track of the mouse feet, as you'll be reapplying them at the end of the guide.

    Editar

  2. Logitech M100 USB Cable Replacement: paso 2, imagen 1 de 2 Logitech M100 USB Cable Replacement: paso 2, imagen 2 de 2

    • Use a Phillips #0 screwdriver to remove the 10mm screws on the bottom of the mouse.

    • Once all screws are removed, use the plastic opening tool to gently pry the mouse apart. This shouldn't take much force.

    Editar

  4. Logitech M100 USB Cable Replacement: paso 3, imagen 1 de 2 Logitech M100 USB Cable Replacement: paso 3, imagen 2 de 2

    • Once the mouse is opened, locate the USB cable's 5-pin connector, which is plugged directly into the mouse's mainboard.

    • Take note of the position and route that the USB cable takes before removal. The replacement cable must follow the same route when inserted.

    • Using a plastic opening tool, gently remove the 5-pin connector from the mainboard.

    Editar

  5. Logitech M100 USB Cable Replacement: paso 4, imagen 1 de 2 Logitech M100 USB Cable Replacement: paso 4, imagen 2 de 2

    • Take the replacement USB cable and connect it to the mainboard.

    Editar

  6. Logitech M100 USB Cable Replacement: paso 5, imagen 1 de 2 Logitech M100 USB Cable Replacement: paso 5, imagen 2 de 2

    • Ensure that the 5-pin connector is fully seated into its slot on the mainboard. You may want to use a spudger to apply pressure onto it.

    • Using a plastic opening tool, route the cable through the case in the same way that was noted in Step 3.

    Editar

  7. Logitech M100 USB Cable Replacement: paso 6, imagen 1 de 1

    • After re-assembling the mouse, don't forget to reattach the mouse feet onto their correct locations on the bottom of the mouse.

    Editar
Conclusión

To reassemble, follow the steps in reverse order.

4 personas más completaron esta guía.

Autor

con 4 otros colaboradores

Jake Janicke

Miembro Desde 10/26/17

161 Reputación

1 Guía escrita

Insignias: 5

+ 2 más insignias

Equipo

DePaul University, Team S1-G5, Dush Fall 2017 Miembro de DePaul University, Team S1-G5, Dush Fall 2017

DPU-DUSH-F17S1G5

2 Miembros

1 Guía escrita

Un comentario

Removing the mouse feet is completely unnecessary, as there are no screws underneath the feet.

Andy Joonseo Bae - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 3

Ultimos 7 días: 12

Ultimos 30 días: 66

Todo El Tiempo: 5,119