Logitech Harmony Companion Remote Motherboard Replacement

Introducción

The motherboard is a central part in the operation of your Companion remote. If your remote is not working after adjusting the settings and replacing the battery, you may need to replace the motherboard. All you need for this guide is a plastic opening tool and a Phillps #0 screwdriver.

Qué necesitas

Paso 1 Remote Battery

Logitech Harmony Companion Remote Motherboard Replacement, Remote Battery: paso 1, imagen 1 de 1

Hold the remote with the Logitech label toward you.

Editar

Paso 2

Push the battery cover upward.

Editar

Paso 3

Logitech Harmony Companion Remote Motherboard Replacement: paso 3, imagen 3 de 3

Use your finger to lift the battery out of the compartment.
When the battery has lifted, push it up to remove it.

Editar

Paso 4 Remote Motherboard

Logitech Harmony Companion Remote Motherboard Replacement, Remote Motherboard: paso 4, imagen 1 de 2

Logitech Harmony Companion Remote Motherboard Replacement, Remote Motherboard: paso 4, imagen 2 de 2

Remove the two 5.0 mm Phillips #0 screws.

Editar

Paso 5

Use the plastic opening tool to pry open the back cover of the remote.
It is recommended to have the point of the opening tool facing the back of the remote.
Insert the opening tool on each side of the bottom of the remote, and pull up until you hear the cover click open.
Pry the back cover off by sliding the plastic opening tool down each side.