Saltar al contenido principal
  1. Press the oval shaped button on the lower back of the remote to release the battery cover. While pressing the button, remove the cover.
    • Press the oval shaped button on the lower back of the remote to release the battery cover.

    • While pressing the button, remove the cover.

  2. Push the battery in, pull it up, and slide it out. Push the battery in, pull it up, and slide it out.
    • Push the battery in, pull it up, and slide it out.

  3. Using tweezers, peel off the sticker located under the battery cover to reveal two screws.
    • Using tweezers, peel off the sticker located under the battery cover to reveal two screws.

  4. Locate and unscrew the four 50mm screws using the Philips #0 screwdriver. Locate and unscrew the four 50mm screws using the Philips #0 screwdriver.
    • Locate and unscrew the four 50mm screws using the Philips #0 screwdriver.

  5. Use a credit card to pry the black, plastic, back cover off of the device.
    • Use a credit card to pry the black, plastic, back cover off of the device.

    • You may need to get the process started with a metal prying tool before you start using the credit card.

  6. Locate the three 50mm screws on the back of the remote and remove them using the Phillips #0 screwdriver. Locate the three 50mm screws on the back of the remote and remove them using the Phillips #0 screwdriver.
    • Locate the three 50mm screws on the back of the remote and remove them using the Phillips #0 screwdriver.

  7. Pry the black, front face of the remote from the back silver part by inserting a credit card in between and sliding down. Again, you may need to use a metal prying tool to get the separation started.
    • Pry the black, front face of the remote from the back silver part by inserting a credit card in between and sliding down.

    • Again, you may need to use a metal prying tool to get the separation started.

  8. When you look at the circuit board, you should see a ribbon attaching the board to the plastic casing. A little lever is holding the ribbon in place. Lift the lever with your nail or a 2.5mm flat-head screwdriver. Move the ribbon away from the circuit board.
    • When you look at the circuit board, you should see a ribbon attaching the board to the plastic casing.

    • A little lever is holding the ribbon in place. Lift the lever with your nail or a 2.5mm flat-head screwdriver. Move the ribbon away from the circuit board.

  9. Using the Philips #0 screwdriver, remove the three 50mm screws from the circuit board. Using the Philips #0 screwdriver, remove the three 50mm screws from the circuit board.
    • Using the Philips #0 screwdriver, remove the three 50mm screws from the circuit board.

  10. Using your hands, carefully separate the motherboard from the rest of the remote.
    • Using your hands, carefully separate the motherboard from the rest of the remote.

Conclusión

To reassemble, follow the steps in reverse order.

John Adams

Miembro Desde 25/09/17

116 Reputación

1 Guía escrita

Equipo

USF Tampa, Team S4-G5, Eyestone Fall 2017 Miembro de USF Tampa, Team S4-G5, Eyestone Fall 2017

USFT-EYESTONE-F17S4G5

4 Miembros

4 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 6

Todo El Tiempo: 353