Logitech G29 Driving Force Force-Feedback Motor Replacement

Introducción

This guide is to show how to replace the two force-feedback motors on the Logitech G29 Driving Force. The Force-feedback motors are what put the resistance on the steering wheel based on what is happening in the game. If these motors go out it can cause the steering wheel to not register the steering inputs that you are putting in.

Qué necesitas

Paso 1 Force-Feedback Motor

Logitech G29 Driving Force Force-Feedback Motor Replacement, Force-Feedback Motor: paso 1, imagen 1 de 1

Remove the six 32mm long 4mm allen screws from the faceplate of the steering wheel

Editar

Paso 2

Now, Remove the six 10mm long #00 Phillips head screws from the back of the steering wheel.
Gently lift off the steering wheel from the hub.

Editar

Paso 3

Carefully unplug the wire connector from the motherboard of the steering wheel

Editar

Paso 4

Using the #1 Phillips head screwdriver remove the three 30mm long screws that are behind the steering wheel.
Gently pull the paddle assembly off from the base of the device and carefully thread the connector through the hole in the center.

Editar

Paso 5

Remove the 15.9mm long silver screws on the bottom of the base of the wheel with a Phillips #1 screwdriver.

Editar

Paso 6

Now remove the four 7.3mm long silver screws from the motherboard using a Phillips #2 screwdriver.
Then, carefully remove the seven plastic connectors from the motherboard. Make sure to avoid pulling by the wires and to only pull on the plastic

Editar