Saltar al contenido principal

Introducción

The disc drive is typically used in a device to read the information from a CD or DVD using an optical sensor. If the disc tray of your Lite-On LightScribe SHM-165H6S has fallen out of alignment or has broken, you can replace it using this guide. This guide is for the mechanical component of the disc drive, but may also help alleviate disc read errors, or can be used to access the optical sensors for cleaning or maintenance.

  1. Insert an open paper clip into the small hole on the left side of the faceplate. After the tray opens, extend it fully.
    • Insert an open paper clip into the small hole on the left side of the faceplate.

    • After the tray opens, extend it fully.

  2. Use an opening device to push in the black tabs on the left, right and bottom of the outer chassis to unhook the faceplate. Use an opening device to push in the black tabs on the left, right and bottom of the outer chassis to unhook the faceplate. Use an opening device to push in the black tabs on the left, right and bottom of the outer chassis to unhook the faceplate.
    • Use an opening device to push in the black tabs on the left, right and bottom of the outer chassis to unhook the faceplate.

  3. Pull the faceplate away from the main chassis.
    • Pull the faceplate away from the main chassis.

  4. Unscrew the four 8.5 mm screws on the bottom chassis using a Philips #2 screwdriver.
    • Unscrew the four 8.5 mm screws on the bottom chassis using a Philips #2 screwdriver.

  5. Lift the top and bottom chassis straight up in order to remove them. Lift the top and bottom chassis straight up in order to remove them.
    • Lift the top and bottom chassis straight up in order to remove them.

  6. Extend the tray fully. Push the tab on the right side to the left. Push the tab on the left side to the left.
    • Extend the tray fully.

    • Push the tab on the right side to the left.

    • Push the tab on the left side to the left.

    • Remove the tray carefully.

  7. Guide the replacement tray under the beige tabs. Make sure the grey piece is slid to the right, so the grey nob is under the right-hand groove of the tray. Check to see that the tray extends and closes smoothly.
    • Guide the replacement tray under the beige tabs.

    • Make sure the grey piece is slid to the right, so the grey nob is under the right-hand groove of the tray.

    • Check to see that the tray extends and closes smoothly.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

James Biggs

Miembro Desde 12/10/11

596 Reputación

3 Guías creadas

Equipo

Cal Poly, Team 6-5, Regan Fall 2011 Miembro de Cal Poly, Team 6-5, Regan Fall 2011

CPSU-REGAN-F11S6G5

2 Miembros

3 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 5

Todo El Tiempo: 3,566