Saltar al contenido principal

Introducción

The Lenovo Yoga battery loses charge quickly. You have already tried unplugging it when it is fully charged, or adjusting the light to save energy. You may need to replace the battery. This guide will help you.

  1. Flip the device having the bottom panel facing you.
    • Flip the device having the bottom panel facing you.

    • Remove the eleven 5mm Torx T5 screws from the back panel.

  2. Remove the back panel carefully.
    • Remove the back panel carefully.

    • To remove the back cover, there are 5 plastic snap hooks that must be dislodged with a spudger or plastic pick tool.

    • Lay the device upside down with hinges away from you. Tilt it at 45 degree angle, leaving hinges down and open the screen slightly. Apply a little pressure on one corner to see where it separates. Then work from side to side to separate the back case from the top case. The back case is a shell with no components in it.

  3. Remove the two 3mm Phillips #1 screws that are holding the battery to the device. Hold the bundled cable connector on each side and carefully pull the connector to release it from the motherboard.
    • Remove the two 3mm Phillips #1 screws that are holding the battery to the device.

    • Hold the bundled cable connector on each side and carefully pull the connector to release it from the motherboard.

  4. Remove the battery carefully from the device by lifting up the edge nearest you and then gently pull toward you to disconnect the power wires.
    • Remove the battery carefully from the device by lifting up the edge nearest you and then gently pull toward you to disconnect the power wires.

Conclusión

To reassemble your device, follow these instructions in reverse order.

3 personas más completaron esta guía.

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 3

Ultimos 30 días: 11

Todo El Tiempo: 2,005