1. First, flip the laptop over as shown in the photo.
    • First, flip the laptop over as shown in the photo.

  2. Below both the bottom left and right of the battery there are locks.
    • Below both the bottom left and right of the battery there are locks.

    • Push them inward toward each other to release the battery.

  3. Gently pull the battery away from the device.
    • Gently pull the battery away from the device.

  4. ¡Envío gratuito para todos los pedidos de más de USD100 o que contengan un Pro Tech Toolkit!

    Visita Nuestra Tienda
  5. On the right side of the back of the laptop, the right most panel will be a shape of an rectangle.
    • On the right side of the back of the laptop, the right most panel will be a shape of an rectangle.

    • Using a Phillips screwdriver, remove the 4 screws that are around the edges of the panel.

    • It is recommend that you fully remove the screw and place them in a secure location.

    • Make sure to use the appropriate screwdriver that fits the screws. Using an incorrect one could the cause the damage to the screws or screwdriver.

  6. Once all the screws are removed, gently slide the metal scalp as seen in the photos. to pray it open then slowly lift the panel up with your hands and then process to lift the other side. Pray it open then slowly lift the panel up with your hands on the left side and then process to lift the other side towards the right.
    • Once all the screws are removed, gently slide the metal scalp as seen in the photos. to pray it open then slowly lift the panel up with your hands and then process to lift the other side.

    • Pray it open then slowly lift the panel up with your hands on the left side and then process to lift the other side towards the right.

  7. The back of the laptop will look like this once the back panel is removed.
    • The back of the laptop will look like this once the back panel is removed.

    • Do not touch any part unless instructed otherwise as many small components can be easily damaged.

  8. After back panel is removed, you can remove the two screws at the bottom of the hard drive using the Phillips #000 screwdriver. After back panel is removed, you can remove the two screws at the bottom of the hard drive using the Phillips #000 screwdriver.
    • After back panel is removed, you can remove the two screws at the bottom of the hard drive using the Phillips #000 screwdriver.

  9. After screws are removed, slide the hard drive down to disconnect from motherboard and remove it.
    • After screws are removed, slide the hard drive down to disconnect from motherboard and remove it.

  10. Now you have successfully removed the Hard drive.
    • Now you have successfully removed the Hard drive.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Brian butler

Miembro Desde 24/10/18

97 Reputación

1 Guía escrita

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 3

Últimos 30 Días: 13

Todo El Tiempo: 78