Saltar al contenido principal

Introducción

Is your Lenovo ThinkPad T410s mouse not moving or frozen? You might want to replace your palm-rest, and this guide will help you replace it!

  1. Flip the laptop over.
    • Flip the laptop over.

    • Push and hold the locking switch to the left.

    • Pull the battery out with your other hand.

  2. Remove the single Phillips #0 screw grin the back panel. Pull the back panel off.
    • Remove the single Phillips #0 screw grin the back panel.

    • Pull the back panel off.

  3. Pull the metal prongs at the side of the RAM away from each other. The RAM will pop out of its socket when done correctly. Pull the RAM out.
    • Pull the metal prongs at the side of the RAM away from each other.

    • The RAM will pop out of its socket when done correctly.

    • Pull the RAM out.

  4. Remove the Flathead 2.5mm screw.
    • Remove the Flathead 2.5mm screw.

    • Flip the laptop over.

  5. Wedge the flat end of a spudger, or plastic opening tool, under the end of the keyboard and pry up. Wedge the flat end of a spudger, or plastic opening tool, under the end of the keyboard and pry up.
    • Wedge the flat end of a spudger, or plastic opening tool, under the end of the keyboard and pry up.

  6. Slide the keyboard out of the way until you can see what's underneath it. The keyboard is still attached with a ribbon cable so don't try to fully remove it.
    • Slide the keyboard out of the way until you can see what's underneath it.

    • The keyboard is still attached with a ribbon cable so don't try to fully remove it.

  7. Use the flat end of a spudger to unplug the keyboard connector from the laptop.
    • Use the flat end of a spudger to unplug the keyboard connector from the laptop.

    • Pull the keyboard out.

  8. Remove the twelve Phillips #0 screws from the back panel.
    • Remove the twelve Phillips #0 screws from the back panel.

  9. Up the flat end of a spudger to lift up the black tab on the ZIF connector. Pull out the ribbon connector from the ZIF connector.
    • Up the flat end of a spudger to lift up the black tab on the ZIF connector.

    • Pull out the ribbon connector from the ZIF connector.

  10. Remove the palm rest from the laptop. Remove the palm rest from the laptop.
    • Remove the palm rest from the laptop.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 1

Ultimos 30 días: 11

Todo El Tiempo: 225