Esta versión puede contener ediciones incorrectas. Cambiar a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Gently insert a spudger into one of the bottom corners between the screen and body case.
-
Slide the spudger along the inside of the crack in order to pry the case open.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
After removing the cover, remove the M1.6 x 2 mm screw from the battery cable with the JIS J000 screwdriver.
-
Remove the tape by gently scraping the edges up with the spudger.
-
-
Este paso está sin traducir. Ayuda a traducirlo
Herramienta utilizada en este paso:Plastic Cards$2.99-
Gently lift the flaps on the four ZIF connectors to disconnect the cables.
-
Use the plastic card to gently pry the battery from the device.
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the tip of a spudger or your fingernail to flip up the small locking flap. Then, you can safely pull the cable out from under the camera.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the press-fit cable located next to the camera by using opening tool to gently pry it up.
-
Unlock the ZIF connector by lifting the black bar and sliding the ribbon cable out.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the five M1.6 x 2 mm screws from the motherboard with the JIS J000 screwdriver.
-
Cut or remove the piece of silver tape from the motherboard.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Use the spudger to gently pry the motherboard out of the frame from each side.
-
Cancelar: No complete esta guía.
6 personas más completaron esta guía.