Repara tus cosas Comunidad Tienda

Lenovo Tab 4 TB-8504F Battery Replacement

Qué necesitas

  1. Lenovo Tab 4 TB-8504F Battery Replacement, Battery: paso 1, imagen 1 de 3 Lenovo Tab 4 TB-8504F Battery Replacement, Battery: paso 1, imagen 2 de 3 Lenovo Tab 4 TB-8504F Battery Replacement, Battery: paso 1, imagen 3 de 3

    • Start at the microSD slot.

    • Use the opening pick to slide underneath the back cover of the tablet.

    • Slide the opening pick around the tablet until the back cover is off.

    Editar

  2. Lenovo Tab 4 TB-8504F Battery Replacement: paso 2, imagen 1 de 3 Lenovo Tab 4 TB-8504F Battery Replacement: paso 2, imagen 2 de 3 Lenovo Tab 4 TB-8504F Battery Replacement: paso 2, imagen 3 de 3

    • Remove the 8 screws with a Phillips #000 screwdriver [bit].

    • There is a screw under the blue "s" sticker.

    • Remove tape holding plate down.

    • Use precision tweezers or your fingers to remove plate.

    Editar

  4. Lenovo Tab 4 TB-8504F Battery Replacement: paso 3, imagen 1 de 2 Lenovo Tab 4 TB-8504F Battery Replacement: paso 3, imagen 2 de 2

    • Remove yellow tape.

    • Use a spudger or plastic opening tool to remove the battery's ribbon cable from the motherboard.

    Editar

  5. Lenovo Tab 4 TB-8504F Battery Replacement: paso 4, imagen 1 de 3 Lenovo Tab 4 TB-8504F Battery Replacement: paso 4, imagen 2 de 3 Lenovo Tab 4 TB-8504F Battery Replacement: paso 4, imagen 3 de 3

    • Gently pull on the two stretch release adhesive strips. Do not pull up, pull away from battery.

    • Once the tabs are off, lift the battery up from the frame.

    • Do not bend or puncture the battery.

    Editar

    Hi

    What I want to ask is how did you get to the motherboard after step four. I couldn't see how you removed the upper protection plastic part.

    I couldn't get it out either!!!

    I wish you good work.

    vedatemre şahin - Contestar

    Be cautious when removing the adhesive strip. Pull it straight ( not up) from the battery a little bit at a time. It is longer than you'd think.

    Arthur Watson - Contestar

    Spot on instructions. Be sure to seat the battery connector very carefully and make sure it doesn't pop off. It look me several tries to seat it.

    Philip F - Contestar

Conclusión

To reassemble your device, follow these instructions in reverse order.

6 personas más completaron esta guía.

Un comentario

Hi,

After replacing the battery, we now get an error “Temperature too high, will shut down” when we boot. We get the same error with the old battery installed. We tried a factory reset. That did not help. I’ve rechecked steps, and it is pretty straighforward. Any ideas?

Thanks,

Dave

David Burris - Contestar

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 3

Ultimos 7 días: 18

Ultimos 30 días: 95

Todo El Tiempo: 6,055