Saltar al contenido principal

Introducción

If your battery cannot hold a charge, and your laptop dies if not plugged in, use this guide to replace your battery.

  1. Turn off your laptop before you begin.
    • Turn off your laptop before you begin.

  2. Remove the nine 6mm screws circled in the picture using a T5 Torx Screwdriver. Remove the two 10mm screws circled in the picture using the same T5 Torx Screwdriver.
    • Remove the nine 6mm screws circled in the picture using a T5 Torx Screwdriver.

    • Remove the two 10mm screws circled in the picture using the same T5 Torx Screwdriver.

  3. After all of the screws are removed, use the iFixit opening tools to carefully snap the black cover off. After all of the screws are removed, use the iFixit opening tools to carefully snap the black cover off.
    • After all of the screws are removed, use the iFixit opening tools to carefully snap the black cover off.

  4. Remove the three 4 mm screws circled in the picture on the left using a T5 Torx Screwdriver. Remove the three 4 mm screws circled in the picture on the left using a T5 Torx Screwdriver.
    • Remove the three 4 mm screws circled in the picture on the left using a T5 Torx Screwdriver.

  5. Gently lift the battery up and locate the connector.
    • Gently lift the battery up and locate the connector.

    • Disconnect it from the motherboard using an iFixit Opening tool or by firmly grasping it and pulling it out.

Conclusión

To reassemble your device, follow these instructions in reverse order.

2 personas más completaron esta guía.

Isaiah Vang

Miembro Desde 04/10/18

645 Reputación

6 Guías creadas

Equipo

UW Stout, Team S6-G6, Ogden Fall 2018 Miembro de UW Stout, Team S6-G6, Ogden Fall 2018

UWSTOUT-OGDEN-F18S6G6

4 Miembros

6 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 4

Últimos 30 Días: 12

Todo El Tiempo: 191