Repara tus cosas Comunidad Tienda

Lenovo IdeaTab A2109 Camera Assembly Replacement

Introducción

Use this guide to replace the front and rear cameras.

Qué necesitas

  1. Lenovo IdeaTab A2109 Camera Assembly Replacement, Camera Assembly: paso 1, imagen 1 de 1

    • Look at the back of the tablet and locate the speakers on top of the rear cover.

    • Locate the small indentation in the plastic cover that runs across the top of the device.

    • Wedge the plastic opening tool in this indentation, under the middle of the cover as shown.

    • Pry up and push to remove the cover.

    Traducir

  2. Lenovo IdeaTab A2109 Camera Assembly Replacement: paso 2, imagen 1 de 2 Lenovo IdeaTab A2109 Camera Assembly Replacement: paso 2, imagen 2 de 2

    • Remove the following two screws:

    • M3.0 x 3.0 mm #00 phillips screws (black)

    Traducir

  4. Lenovo IdeaTab A2109 Camera Assembly Replacement: paso 3, imagen 1 de 3 Lenovo IdeaTab A2109 Camera Assembly Replacement: paso 3, imagen 2 de 3 Lenovo IdeaTab A2109 Camera Assembly Replacement: paso 3, imagen 3 de 3

    • Pry open the front and rear faces using a plastic opening tool.

    • It may take a little force to separate the front and rear faces of the device.

    • Slide the plastic opening tool to one corner.

    • Place another plastic opening tool into the gap and slide it to the opposite corner as shown.

    • Pull the rear cover up and back to separate it from front face of the device.

    Traducir

  5. Lenovo IdeaTab A2109 Camera Assembly Replacement: paso 4, imagen 1 de 1

    • Slide the rear camera ribbon from the system board.

    • Pull up on the black plastic lock on the system board for the front camera and slide the ribbon out.

    • Now, you are ready to remove the front and rear facing cameras.

    Traducir
Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Autor

con 6 otros colaboradores

Abigail Bertholf

Miembro Desde 04/14/14

521 Reputación

1 Guía escrita

Insignias: 9

+ 6 más insignias

Equipo

Cal Poly, Team 7-19, Regan Spring 2014 Miembro de Cal Poly, Team 7-19, Regan Spring 2014

CPSU-REGAN-S14S7G19

4 Miembros

15 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 0

Ultimos 30 días: 2

Todo El Tiempo: 577