Saltar al contenido principal

Introducción

This hard drive replacement guide will show you how to properly remove the hard drive from your Lenovo IdeaPad. The only tool mandatory for this guide will be a #1 Phillips head screw driver and a metal spudger.

Partes

No se especificaron partes.

  1. Using the metal spudger, remove all the rubber squares on the bottom of the laptop. Using the metal spudger, remove all the rubber squares on the bottom of the laptop.
    • Using the metal spudger, remove all the rubber squares on the bottom of the laptop.

  2. Remove the three 6 mm Phillips #1 screws  holding the panel on the laptop. Pry the panel from the laptop using your hands or the metal spudger if necessary. Pry the panel from the laptop using your hands or the metal spudger if necessary.
    • Remove the three 6 mm Phillips #1 screws holding the panel on the laptop.

    • Pry the panel from the laptop using your hands or the metal spudger if necessary.

  3. Locate the hard drive in the bottom left corner.
    • Locate the hard drive in the bottom left corner.

  4. Kits de Reparación de Android

    A new screen or battery is one kit away.

    Comprar Ahora

    Kits de Reparación de Android

    A new screen or battery is one kit away.

    Comprar Ahora
  5. Use the Phillips #1 screwdriver to remove the three 3mm screws located on the rim of the hard drive. Use the Phillips #1 screwdriver to remove the three 3mm screws located on the rim of the hard drive.
    • Use the Phillips #1 screwdriver to remove the three 3mm screws located on the rim of the hard drive.

  6. Use your fingers to detach the black connector from the hard drive. Use your fingers to detach the black connector from the hard drive. Use your fingers to detach the black connector from the hard drive.
    • Use your fingers to detach the black connector from the hard drive.

  7. Unscrew the four screws on either side of the hard drive with the Phillips #1 screwdriver. Unscrew the four screws on either side of the hard drive with the Phillips #1 screwdriver.
    • Unscrew the four screws on either side of the hard drive with the Phillips #1 screwdriver.

  8. Use your fingers and gently lift the hard drive from the case it was screwed into.
    • Use your fingers and gently lift the hard drive from the case it was screwed into.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Una persona más ha completado esta guía.

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 5

Últimos 30 Días: 18

Todo El Tiempo: 215