Repara tus cosas Comunidad Tienda

Lenovo Flex 3-1120 Speakers Replacement

Introducción

If sound output is distorted, or no sound is coming from your speakers at all, then your speakers may need to be replaced.

Qué necesitas

  1. Lenovo Flex 3-1120 Speakers Replacement, Bottom Panel: paso 1, imagen 1 de 1

    • Lay the computer down with the bottom panel facing up.

    Editar

  2. Lenovo Flex 3-1120 Speakers Replacement: paso 2, imagen 1 de 2 Lenovo Flex 3-1120 Speakers Replacement: paso 2, imagen 2 de 2

    • Locate the ten 6mm Phillips screws along the edges and in the center of the back panel.

    • Remove all ten 6mm Phillips screws with a size 0 Phillips screwdriver.

    Editar

  3. Lenovo Flex 3-1120 Speakers Replacement: paso 3, imagen 1 de 1

    • Wedge the plastic opening tool into the small space under the back panel.

    • Use the plastic opening tool as a lever to separate the bottom panel from the computer.

    • Slide the tool along the edges of the computer until the bottom panel is completely separated.

    • You may start prying the bottom panel on any edge.

    Editar

  5. Lenovo Flex 3-1120 Speakers Replacement: paso 4, imagen 1 de 1

    • Lift the bottom panel off of the computer.

    Editar

  6. Lenovo Flex 3-1120 Speakers Replacement, Speakers: paso 5, imagen 1 de 1

    • Locate the speakers at the bottom left and right corners of the computer.

    Editar

  7. Lenovo Flex 3-1120 Speakers Replacement: paso 6, imagen 1 de 2 Lenovo Flex 3-1120 Speakers Replacement: paso 6, imagen 2 de 2

    • Locate the two 1mm Phillips head screws on both speakers.

    • Remove both screws from each speaker.

    Editar

  8. Lenovo Flex 3-1120 Speakers Replacement: paso 7, imagen 1 de 2 Lenovo Flex 3-1120 Speakers Replacement: paso 7, imagen 2 de 2

    • Locate where the two speaker wires join at the center of the computer.

    • Follow the wires directly upward to where they connect into the motherboard.

    Editar

  9. Lenovo Flex 3-1120 Speakers Replacement: paso 8, imagen 1 de 1

    • Using the spudger, pull the wire down and away from the motherboard to disconnect it.

    Editar
Conclusión

To reassemble your device, follow these instructions in reverse order.

Autor

con 2 otros colaboradores

Geoff Bentz

Miembro Desde 03/09/16

934 Reputación

5 Guías creadas

Insignias: 17

+ 14 más insignias

Equipo

UMass Dartmouth, Team 7-1, Catania Spring 2016 Miembro de UMass Dartmouth, Team 7-1, Catania Spring 2016

UMASSD-CATANIA-S16S7G1

4 Miembros

7 Guías creadas

0 comentarios

Agregar Comentario

Ver Estadísticas:

Ultimas 24 horas: 0

Ultimos 7 días: 2

Ultimos 30 días: 2

Todo El Tiempo: 397