Introducción

A guide on how to replace the camera in a LeapFrog LeapPad Ultimate.

Herramientas

No se requieren herramientas.

Partes

No se requieren partes.

  1. Flip over the Pad to its back side to begin the removal of the back panel.
    • Flip over the Pad to its back side to begin the removal of the back panel.

    • Begin by removing the blue rim along the edge of the device. It runs along the green silicone lining.

    • This is very difficult to remove , so do be patient. To help remove the seal, both a metal spudger and plastic opening tool may be used.

    • Remove the pen from its place before starting to avoid tangling.

  2. Once the blue rim is removed, the 12 screws will be visible.
    • Once the blue rim is removed, the 12 screws will be visible.

    • Use the Phillips #1 screwdriver to unscrew all 12 screws.

    • Remove the 3 screws on each corner of the motherboard

    • Remove the ribbon on the bottom of the motherboard and the ribbon on the left side of the motherboard.

    • There will be a small black switch on top of the ribbons that you must flip to take them out.

    • Remove the 3-pin connector on the top left side of the motherboard.

    • Flip the motherboard to its back side and pinch the 2 green hooks to remove the camera cover

    • Remove the ribbon connecting the camera to the motherboard. You have now taken out the camera and can replace it with a new one.

Conclusión

To reassemble your device, follow these instructions in reverse order.

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 1

Últimos 30 Días: 19

Todo El Tiempo: 35