N-Strike Nite Finder EX-3 Leaf Spring Switch Replacement Guide

Introducción

If the laser is not turning on, or flickering on your N-Strike Nite Finder EX-3, the problem may be caused by a faulty leaf spring. In order to replace this part, follow the steps in this guide.

Qué necesitas

Paso 1 Leaf Spring Switch

N-Strike Nite Finder EX-3 Leaf Spring Switch Replacement Guide, Leaf Spring Switch: paso 1, imagen 1 de 1

Place the blaster upside down on the table, and remove the screw in the bottom of the handle.
Remove the battery door and take the batteries out.

Editar

Paso 2

N-Strike Nite Finder EX-3 Leaf Spring Switch Replacement Guide: paso 2, imagen 3 de 3

Set the blaster on its side with the screws facing up (the blaster will be placed on its left side). Remove all 14 phillips head, 8.2 mm screws and set them aside.
Lift the side of the blaster off exposing its internal parts.

Editar

Paso 3

Work the trigger to ensure the problem is the switch not making a proper connection.
Remove the retaining phillips head 10.2 mm screw below the switch.

Editar