Introducción

The front keypad suffers a lot of wear-and-tear, but can be easily replaced. This guide will show you how to remove the old keypad so that you may install a new one.

Partes

No se requieren partes.

Remove the two triangular pads at the top of the two speakers.
  • Remove the two triangular pads at the top of the two speakers.

  • These pads have adhesive to keep them situated, so you may want to use a fine-tipped object, such as a screwdriver or a pen, to remove them. It is easiest to place the fine-tipped object in the small indent in the corner of these pads.

Agregar Comentario

Remove the two rubber cylinders from their shafts. These cover more screws.
  • Remove the two rubber cylinders from their shafts. These cover more screws.

  • This requires a little more effort, so you may need to "dig" them out.

Agregar Comentario

Now remove the four screws.
  • Now remove the four screws.

  • The screws are small, so put them somewhere that you can easily keep track of them.

Agregar Comentario

Starting on the side with blue square, pry the faceplate upwards with the flat end of a spudger.
  • Starting on the side with blue square, pry the faceplate upwards with the flat end of a spudger.

    • Continue to slide the flat edge along the seam of the faceplate.

  • You should hear popping or snapping noises as the faceplate is being removed.

Agregar Comentario

The faceplate is attached by wires, so do not pull the faceplate very far away from the phone. The faceplate is attached by wires, so do not pull the faceplate very far away from the phone.
  • The faceplate is attached by wires, so do not pull the faceplate very far away from the phone.

Agregar Comentario

The faceplate is still attached through speakers that travel from the ear-piece to the motherboard. Carefully wedge the flat or pointed end of the spudger beneath the ear-piece and the faceplate. This may require a bit of force, as the ear-piece is stuck to the faceplate with adhesive.
  • The faceplate is still attached through speakers that travel from the ear-piece to the motherboard.

  • Carefully wedge the flat or pointed end of the spudger beneath the ear-piece and the faceplate.

  • This may require a bit of force, as the ear-piece is stuck to the faceplate with adhesive.

Agregar Comentario

The faceplate and keypad can now be completely removed from the phone.
  • The faceplate and keypad can now be completely removed from the phone.

Agregar Comentario

Linea de Meta

Aaron Rowley

Miembro Desde 21/01/10

33 Reputación

2 Guías creadas

Equipo

Cal Poly, Team 16-32, Maness Winter 2010 Miembro de Cal Poly, Team 16-32, Maness Winter 2010

CPSU-MANESS-W10S16G32

4 Miembros

4 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 0

Todo El Tiempo: 1,832