Esta versión puede contener ediciones incorrectas. Cambie a la última instantánea verificada.
Qué necesitas
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the back cover by sliding the tab away from the phone using one finger.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Lift one side of the battery using a plastic opening tool or your fingers.
-
Carefully remove the battery and set it aside.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Turn your phone around and open the flip phone.
-
Locate the two grey rubber plugs on the LCD portion of the phone. These plugs cover up two screws.
-
Remove the two grey screw-covers at the bottom of the screen
-
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the screen by using the tab to eject the screen.
-
There is a gap between the case and the screen near the ear piece
-
Insert the plastic opening tool in the gap and pry the screen up.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Unscrew the four corner 3.21mm screws to separate the the top cover of the phone
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Turn your phone around
-
Remove the top cover of the phone by inserting the plastic opening tool into the groove.
-
Carefully open the cover.
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Desolder the top ear piece using a soldering iron to remove the component
-
The ear piece is the black component that is located at the top with black and red wires
-
-
Este paso está sin traducir. Ayuda a traducirlo
-
Remove the ear piece from the phone by lifting it using a plastic opening tool.
-