Introducción

Steps to remove LG VX8550 keypad housing

  1. Slide the battery release up.
    • Slide the battery release up.

    Agregar Comentario

  2. Remove the battery by lifting away from the case.
    • Remove the battery by lifting away from the case.

    Agregar Comentario

    • Remove the 2 screw covers next to the rear speaker with a Push Pin.

    Agregar Comentario

    • Remove the 4 cover screws with a Philips #00 screwdriver.

    Agregar Comentario

    • Use the iPod opening tool to pry off the back casing.

    Agregar Comentario

    • Continue sliding the iPod opening tool around the seam of the casing to separate the front and back casings.

    Agregar Comentario

    • Separate the casing halves.

    • Be sure to keep track of the side buttons as they fall out.

    Agregar Comentario

    • Remove the 2 screws from the back of the phone with a Phillips #00 Screwdriver.

    Agregar Comentario

    • Carefully lift up on the motherboard to see the ribbon cables underneath.

    • Use the spudger to carefully disconnect the ribbon cable from the motherboard.

    Agregar Comentario

    • Remove the motherboard from the front casing by lifting straight up.

    Agregar Comentario

    • Lay the phone with the screen facedown.

    • The 6 slider screws are visible.

    Agregar Comentario

    • Peel back but don't remove the blue tape to access the 2 center screws.

    • Remove the 6 slider screws with the Phillips #00 screwdriver.

    Agregar Comentario

    • Lift the keypad housing away from the slider.

    Agregar Comentario

Conclusión

To reassemble your device, follow these instructions in reverse order.

Nathan Jones

Miembro Desde 10/04/10

83 Reputación

10 Guías creadas

Equipo

Cal Poly, Team 34-55, Forte Spring 2010 Miembro de Cal Poly, Team 34-55, Forte Spring 2010

CPSU-FORTE-S10S34G55

5 Miembros

20 Guías creadas

Agregar Comentario

Ver Estadísticas:

Ultimas 24 Horas: 0

Últimos 7 Días: 0

Últimos 30 Días: 1

Todo El Tiempo: 1,840